Your shopping cart is empty!
Improved booster in a new metal can. The lid has a special brush for application.
The table tennis booster is used by many top table tennis players - Ma Long, Hao Shuai, Lia Xiaoxia, Guo Yang, etc. Even Timo Ball uses a table tennis booster.
VOC level < 2ppm
Volume 100 ml.
Instructions for use
NEW RUBBERS
1. If you are using a new generation of "charged" rubbers like the Neo Huricane, remove the plastic adhesive film from the sponge of the rubber. Nothing should interfere with the boosting process.
2. Apply water glue to the sponge. Let the glue dry. This may take about 5 minutes depending on the temperature. When the glue dries it will change color from white to transparent. It is recommended to apply 2-4 layers of adhesive in this way, depending on the viscosity of the adhesive. If the adhesive is more viscous, then the number of applied layers is reduced to two.
3. Apply the table tennis booster to the sponge on the back of the playing surface of the rubber. The layer should not be very thick. Wait until the table tennis booster is completely absorbed into the sponge. For traditional Chinese overlays, it is recommended to repeat the process 3-4 more times, for Japanese/German overlays 1-2 more times.
4. Keep the rubbers for 6 days at room temperature and not in high humidity.
5. After 6 days, apply one coat of adhesive to the blade. Now you can glue the rubber to the blade.
RE-TUNING
The table tennis booster keeps the effect for 1 month. Re-tuning is necessary if you feel that the effect has diminished.
1. After peeling the rubber from the blade, apply 1 coat of Table Tennis Booster directly onto the sponge. No need to remove the layer of old glue.
2. Leave the rubber on for approximately 10 hours.
3. Apply water-based glue to the blade, let it dry and glue the rubber and blade together.
It is important that the table tennis booster layer is completely dry before you glue the rubber to the blade!
| Glues | |
| Category | boosters |
